Startup Request

Step 1 of 5

20%

Job Name(Required)

Jobsite Address(Required)

Startup Contact(Required)

Email(Required)

Phone Number(Required)

PPE Requirements

Hard Hat

Safety Glasses

High Visibility Vest

Protective Footwear

Other Notes or Requirements

Is Your System Ready

Manufacturers will not be held liable for any damage caused by not following instructions. Failure to adhere to these instructions and manufacturer’s instructions may void factory warranty. If the following items are not complete, note reasons and expected completion date(s).

Checklist

All relays/dimmers installed, if applicable

All switches installed, if applicable

All sensors installed, if applicable

Correct cable used per Manufacturers recommendation, if applicable

All data connections wired per shop drawings &/or control schedule on plans and specifications

All terminations (data & line voltage) completed and verified

All dirt and debris removed from equipment

All equipment is accessible

Have all Manufacturer Specific System Installation Checklist(s) been completed?

Checklist(s) - Select All That Apply

Please send completed checklist(s) to [email protected]

Fresco

LC&D/BlueBox

nLight Air

nLight Stand Alone

nLight Networked

EchoFlex

ETC

Lumenpulse

Nextlight

Other

Checklist Notes

(If checklist(s) have not been completed, note reason(s) below. Checklist(s) must be completed prior to startup.)

Programming/Startup Request

Allow for 2 weeks advance notice prior to programming. Contact project manager at JRC Inc. to schedule programming/startup. Only one session will be conducted (unless otherwise negotiated.) Return trips due to project not being ready for programming/startup will result in additional charges.

I would like to schedule startup for: (1st Choice)(Required)

MM slash DD slash YYYY

I would like to schedule startup for: (2nd Choice)

MM slash DD slash YYYY

Training Request

Allow for 2 weeks advance notice prior to training. Contact your project manager at JRC Inc. to schedule training. Training can be provided the same day as programming if feasible. Only one session will be conducted (unless otherwise negotiated.) It is the responsibility of the installing contractor to ensure all appropriate people are invited to attend training. Return trips due to project not being ready for training will result in additional charges.

Training Request

I would like to schedule Training at the same time as startup.

Training at a later date.

Select Training Date

MM slash DD slash YYYY

Distributor

Phone

Electrical Contractor

Project Foreman

Phone

I hereby certify that all conditions have been met to proceed with startup and training and that the installation is complete, or will be complete, by the requested date above. I also understand that additional charges will be incurred for additional site visits due to unprepared jobsite or lack of correct personnel available for training.

Signature(Required)

Date

MM slash DD slash YYYY

*** If you don’t receive an Automated response, please contact us to verify we received the startup request. ***